Coolangatta Core Drilling

Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)

Why Us?

Cut It Out Concrete Sawing and Core Drilling are Australian-owned and family-run, and are the #1 providers of safe, reliable and cost-efficient concrete cutting services in Coolangatta.
Category:

    About Coolangatta core Drilling

    Cut It Out Concrete Sawing and Core Drilling are the #1 providers of safe, reliable and cost-efficient Core Drilling services in the Coolangatta region.

    Diamond core drilling utilises an annular diamond-impregnated drill bit attached to the end of hollow drill rods to cut a cylindrical core of solid rock (or masonry). The diamonds used are fine to microfine industrial grade diamonds. They are set within a matrix of varying hardness, from brass to high-grade steel. Matrix hardness, diamond size and dosing can be varied according to the rock which must be cut. Holes within the bit allow water to be delivered to the cutting face. This provides three essential functions; lubrication, cooling, and removal of drill cuttings (in this case, fine slurry), without which drilling cannot continue. The core is retrieved via use of a core lifter, a hollow tube inserted into the core barrel which slides over the core as it is cut. A tool is sent down and locks on to the core lifter, and pulls the lifter and its core to surface. Once complete it leaves a neat circular penetration. This type of drilling is one of the only ways to drill through heavy steel re enforced concrete.

    Application

    The procedure involves bolting anchor points of the drilling mast to the concrete surface to be core drilled. Or if the surface is a finished surface ie tiled floors walls or painted finished walls, a vacuum pad and pump is used which does not require bolting anchor points into the surface.

    During drilling with a circular drill bit, water from a hose connected to a tap is flushed down the hole to capture dust, remove slurry and keep the drill bit cool. This procedure is common for all core drilling equipment, despite the fact that most equipment is electricity driven.

    Core drilling has a large range of applications where a cirucluar holes is required completely or partway through a floor or wall made of bricks, blocks, stone or concrete,these may include:

    • Air conditioning pipes
    • Electrical conduits and cables
    • Ballard installation
    • Plumbing pipes
    Coolangatta Core Drilling by the Harbour

    Coolangatta Core Drilling by the Harbour

    Drill Operator vac pad drilling in Coolangatta

    Drill Operator vac pad drilling in Coolangatta

    Drill Operator Core Drilling in Coolangatta

    Drill Operator Core Drilling in Coolangatta

    Sizes

    Core holes are available starting from 14 mm up to 400 mm in diameter. They can go larger pending on the requirement.

    Depth

    Core holes can be drilled to almost any depth starting at 5 mm deep.

    Core Drilling Service Map, Coolangatta

    Note: If you are in another location to the ones listed above, please do not hesitate to contact us and we can look at coming to you or recommend another contractor.

    Pricing

    The price of core holes is based on the diameter of the core barrel used, and the depth in which it is drilled to. Another factor whether it’s being drilled vertically or horizontally. Prices are consistent in Coolangatta and across all service areas and regions.

    Why not Contact Us to discuss your needs further.

    Core Drilling Photo Gallery

    1 review for Coolangatta Core Drilling

    1. Rated 5 out of 5

      Cut It Out Concrete Sawing and Core Drilling are Australian-owned and family-run, and are the #1 providers of safe, reliable and cost-efficient Core Drilling services in Coolangatta.

    Add a review

    Your email address will not be published. Required fields are marked *